Here's how I did it: // your chart componentĬonst hasNegative = chartData.some((it) => it.value it. I had this problem at work and just solved it perfectly, You need to determine if there are any negative values in the incoming chart data, and of course, you want to avoid all negative values, so you also need a Boolean value to determine if the values are all negative. Summing up: I need to always display the 0 value on the value axis AND be able to display negative values. the maximum value of the y axis (ignored if chart data contains a higher value) Outputs. minimum set to 0 and one of the values set to a negative value. foldername, move to it using the following command. Step 2: After creating your project folder i.e. Previously, in order to format the number, developers had to. Under Tooltip -> Formatting, I see an option called Value decimals which. The issue is that the Vertical Axis is showing percentages or factor values, not dollar values. The following commit(s) were added to refs/heads/tooltip-value-formatter by this push: new cbdf73b test e-mail: email protectedecharts. Set 2: Needed to Reach Goal: Value in B4 - Calculated Value base on formula (B5-B3) In this case I have a Goal: Cell B5 with a value of 40,000 and lets say that B3 is 20,000 which makes B4 20,000. Step 1: Create a React application using the following command. Set 1: Donations to Date: Value in B3 - Entered data. This is what I get with the minimum property set to 0 and one of the data points set o a negative value: Then add multiple Bar charts using Bar component and to get them stacked on top of each other use the same stackId for all charts. But when I set any of the values to be negative, it does not display on the chart. I know I can set the minimum propert of the value axis to 0 to achieve my desired result. I need it to always start counting from 0, so I can compare the columns relatively to each other in a visual way. I also want to hide the labels on the value axis at some point.Īs you can see, value axis starts counting from 22.5. This is all good, but the thing is that I need to be able compare my columns visually. The results of example 2 and example 4 are the same. Step 2: The chart appears, as shown in the following image. The values are quite clse to eachother so amCharts decides to hide the 0 value axis and dislay only the relevant data. The steps to create a 100 3-D stacked bar chart are listed as follows: Step 1: In the Insert tab, click Column Charts (in Charts section) and select 100 3-D stacked bar. I am creating a simple serial chart, displaying columns for two simple data series.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |